- For direct surface mounting on non-flat surfaces or surfaces with projections over the mounting area
- Clean all wax & dirt from fixing area using the cleaning sachet
- Apply 4 pads in position to reverse of number plate & remove protective film
- Hold for 10 seconds to ensure good contact, full bonding strength reached after 24 hours
- Minimum application temperature is 10c
- Avoids holes in car
- No drilling of number plates
- Full fitting instructions included
- Fits one number plate
The Sticky Pads are for direct surface mounting on non-flat surfaces or surfaces with projections over the mounting area. Ensure you clean all wax and dirt from fixing area and reverse of number plate using the cleaning sachet. The spacer pad must be checked to make sure it accommodates the slight curves on some mounting surfaces and projections on others. Apply four pads in position to reverse of the number plate and remove protective film from pads and press firmly into position. Hold for ten seconds to ensure good contact. Full bonding strength is reached after 24 hour and the minimum application temperature is 10c.